Page 41
DMS-AV HOME THEATER AMPLIFIER
Automated Speaker Setup
All of the manual room correction described in the previous section can be
accomplished through an automated process, within the on-screen display,
or the URC Accelerator Application. Included with each DMS-AV is a
setup microphone, which when connected to the DMS-AV Setup Mic input,
can be used to perform an automated room correction routine. The internal
DSP of the DMS-AV shall execute a series of test tones to each speaker in
the installation, which will then automatically determine each speaker
level, correct speaker distance setting and crossover frequency. These
settings will be automatically saved within the DMS-AV firmware, and URC
Accelerator, if applicable.
Input Settings
Each of the 12 inputs on the DMS-AV supports parameters that allow for
customization for each input and their function.
Input Rename
Each input may be renamed to better de scribe its function. The maximum
amount of characters that can be used to rename an input is eight.
The input name can be set in the DMS-AV on-screen display, or
within the URC Acceler ator Application.
Digital Audio Assign
(Available for all inputs except Phono) – Each input may have their
audio input reassigned to any of the two optical digital or coaxial
digital (S/PDIF) inputs. The two optical digital inputs are named
IN A and IN B, and the two coaxial digital inputs are named IN C
and IN D. Digital audio assign options may also be used to reassign
HDMI audio, in the case that a DVI input is used, requiring the use
of a separate audio input.
The Set up Microphone included should be the only
microphone used in the automatic setup configuration.