Features and Benefits
Interference Rejection and Adjustable RF Range via RFX-150
The MRF-300 receives RF (radio frequency) signals via the RFX-150 RF Sensor. The RFX-150 displays RF interference via a bright RED LED, which flickers when interference is present. Simply relocate the RFX-150 out of the interference or reduce the range to eliminate interference via the RF Range adjust screw.
Expand Range by Adding RFX-150 RF Sensors in Remote Areas The MRF-300 can power up to three RFX-150 RF Sensors connected in parallel to the RF Input connector.
Variable IR Output Matches Rear Panel IR Inputs
The MRF-300 is equipped with adjustable IR line outputs, each output can be indi- vidually matched to rear panel IR inputs on any component that is designed to be operated by a standard IR repeater.The outputs utilize a 3.5mm jack.
Up To Fifteen Equipment Locations With Identical Components Each URC MX series “addressable” remote control can be programmed to specifically control components in a particular room, by installing a base station at each location. In operation it’s simple: when you select a device located in the Den, the MX series remote only sends commands to the Den. When you select a device located in the Family Room, the MX-3000 only sends commands to it.
A Single MRF-300 Can Control an Array of Identical Components or Identical Zones of a Multi Zone Preamp/Matrix Switcher
Each MRF-300 has six “addressable” IR Line Outputs. For example, you can con- trol up to six identical TV’s with one MRF-300 or route volume commands for a specific zone to a particular zone IR input on a multi-zone preamp. If you have more than six identical components or zones, up to 15 additional MRF-300’s can be installed to control them (thus allowing up to 90 identical components or zones in one house).
IR Input for Keypads or IR Repeater Systems
The MRF-300’s rear panel IR input will relay IR Data from IR repeaters or Multi- Zone Keypads to all IR line outputs (does not support IR routing).The 5V, 100 milliamp output will directly power some brands and models of keypad directly.
Parts Guide
The MRF-300 RF Base Station includes:
1 - RFX-150 RF Sensor with integrated antenna 1 - MRF-300 Base Station
1 - Mounting Plate for wall mounting the MRF-300 4 - Screws for wall mounting the mounting plate 1 - 9V-300mA Power Supply
6 - Visible Flashers with 10 foot plug in cables.
1 - 10’ cable with Tinned leads to 3.5 mono mini plug (connects RFX to MRF) 1 - 10’ cable with 3.5 to 3.5 (connects MRF to MRF for expansion)
1 - RF Adjustment Tool (Screwdriver for RFX-150 adjustment)
Page 2
