Universal Remote Control Unifier URC-100 owner manual Basic Setup, Pre-Programmed Method

U R C - 1 0 0

Basic Setup

You can start setting up your Unifier using either the Pre-Programmed Method or the Learning Method. However, all the buttons of the Unifier are setup at once with the Pre-Programmed Method, so it is usually faster than the one-button-at-a-time Learning Method.

Pre-Programmed Method

1Power on the A/V component you wish to setup, so that you can test codes by sending power off commands.

2Refer to the pre-programmed code tables on pages 25 - 46 and write down the code numbers listed for your A/V component. The code numbers are listed by categories of devices, then by brand. See page 25 for a category list.

3Press and hold both the SHIFT and ENT (Enter) buttons for approximately three seconds. The top of the display will blink “SET” then one of the eight device names. You are in SETUP mode now.

Note: You have 30 seconds to perform a step while you are in SETUP mode. If you don’t press a button within that time, the Unifier will time out and return to normal operation.

SHIFT	ENT
Button	Button

5