Universal Remote Control Unifier URC-100 Advanced Setup, Own Two VCR’s? Set Aux to be VCR2

U R C - 1 0 0

Advanced Setup

After you’ve finished all your basic setup, you can choose to make operation easier by customizing the Unifier just the way you want, using the Advanced Setup features described in this section.

Own Two VCR’s?

Set Aux to be VCR2

Any device button can be setup for ANY type of component (for example, you can make the AUX device button operate a second VCR). To setup a device button for a different type of component, use these steps:

1Power on the A/V component you wish to setup, so that you can test codes by sending power off commands.

2Refer to the pre-programmed code tables on pages 25 - 46 and write down the code numbers listed for your A/V component.

3Press and hold both the SHIFT and ENT (Enter) buttons for approximately three seconds. The top of the display will blink “SET” for a moment.

SHIFT	ENT
Button	Button

Note: You have 30 seconds for each step, otherwise the Unifier will time out automatically.

13