Install Clock Backup Battery
The iP47 uses 3 x AA backup battery system to provide backup alarm operation and clock settings in the event of a power failure. If the Backup Battery has been installed and a power failure occurs or the AC cord is accidentally disconnected, the display backlight will not remain lit, but current time and alarm time settings will be temporarily maintained. Otherwise, you must reset the time and alarm settings.
1.Open backup battery compartment door located on the bottom of the unit.
2.Please make sure the AC adaptor is connected. Otherwise all settings may be lost during battery replacement.
3.Insert 3 AA batteries, checking that the polarity (+ and – ends of the battery) matches the drawing near the battery compartment. Close the compartment door.
Replace Backup Battery |
Note: Make sure you dispose of batteries properly (see your local regulations).
Replacing the Remote Control Battery
The remote control battery is already installed at the factory. When the remote control stops operating or its range seems reduces, it is time to replace a new one.
1.The battery door is located on the back end of the unit.
2.Pull the battery door to release the battery door latch and take out the battery holder.
3.Insert a CR2032 battery, checking the + and – ends of the battery is matching to the drawing inside the battery compartment.
4.Replace the battery holder back into the remote control.
Note: Make sure you dispose of batteries properly (see your local regulations).
For best results, aim remote control towards the remote sensor on the lower center of the unit.
Battery Door |
10
