14
INSTALLATION
Installing Logs (Cont.)
OPERATING FIREPLACE -
For Your Safety Read Before Lighting
INSTALLATION
Continued
3.Slide the grooves in the back of the rear log (#3) against the rear grate prongs. Make sure the peg on the log is on top (see Figure 25).
4.Place the crossover log (#4) on the rear log and the middle log. Make sure the peg on the rear log is in the hole in the bottom of the crossover log. The crossover log should fit in the cutout of the middle log (see Figure 26).
5.Install fireplace screen by slipping notches of fireplace screen over screws on front of fireplace (see Figure 27).
WARNING: You must operate this fireplace with the fireplace screen in place. Make sure fireplace screen is in place before running fireplace.
Groove in | Peg | |
| ||
Back of Log | Rear Log (#3) | |
| ||
Grate Prong |
| |
Rear Burner | Groove in | |
Back of Log | ||
| ||
| Grate Prong |
Figure 25 - Installing Rear Log (#3)
Crossover Log (#4)
Hole
Cutout
Peg
Figure 26 - Installing Crossover Log (#5)
Screws for
Mounting
Screen
Notches
Figure 27 - Installing Fireplace Screen
OPERATING FIREPLACE
THERMOSTAT-CONTROLLED MODELS
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing prop- erty damage, personal injury or loss of life.
A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire de- partment.
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service techni- cian or gas supplier. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
For..com