OWNER’S MANUAL
OPERATING
FIREPLACE
Continued
Pilot Burner | Ignitor |
| Electrode |
Figure 35 - Pilot
TO TURN OFF GAS
TO APPLIANCE
Shutting Off Heater
1.Turn control knob clockwise to the OFF position.
2a. Set selector switch in the OFF position.
2b. If Using Optional
Shutting Off Burner Only (pilot stays lit)
You may shut off the burner and keep the pilot lit by doing one of the following:
1.Turn control knob clockwise to the PILOT position.
2.Use remote control manual OFF button.
3.Set selector switch in the OFF position.
MANUAL LIGHTING
PROCEDURE
OPTIONAL REMOTE
OPERATION
Note: All remote control accessories must be purchased separately (see Accessories, pages 26 and 27). Follow installation in- structions included with remote control.
Thermostat Control Operation
(Optional GHRCT Only) The thermo- stat control setting on the remote control unit can be set to any comfort level be- tween HI and LO. The burner will turn on and off automatically to maintain the comfort level you select. The ideal com- fort setting will vary by household de- pending upon the amount of space to be heated, the output of the central heating system, etc.
For wall thermostat operation, follow in- struction supplied with thermostat acces- sory GWMT1. For wall switch operation follow instructions supplied with GWMS2.
NOTICE: You must light the pilot before using the
1.After lighting, let pilot flame burn for about one minute. Turn control knob to ON position. Adjust flame adjust- ment knob anywhere between HI and LO. Slide the selector switch to the REMOTE position. Note: The burner may light if
IMPORTANT: Do not leave the selec- tor switch in the REMOTE position when the pilot is not lit. This will drain the battery.
IMPORTANT: Be sure to press the ON/OFF buttons on the hand held remote control unit for up to 3 sec- onds to assure proper operation.
GHRC Series Operation:
2a. Press the ON/OFF button to turn the burner on and off. When turning burner off, the pilot will remain lit.
GHRCT Series Operation:
2b. Select the MAN (manual) or AUTO button on the
•In manual mode, turn burner on or off by pressing the ON or OFF buttons on the
•In auto mode, the room tempera- ture is controlled by the thermostat in the
IMPORTANT: This remote control has been specially engineered to take an air temperature sample every 5.5 minutes in the AUTO mode. It will not respond immediately to the tempera- ture setting being turned up or down.
1.Follow steps 1 through 6 under Light- ing Instructions, page 18.
2.Depress control knob and light pilot with match.
3.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Now follow steps 9 through 11, page 18.
| Control Knob |
|
|
|
|
|
|
|
|
| Flame |
REMOTE |
|
|
| OL | Adjustment |
O |
|
|
| Knob | |
OFF |
|
|
| ||
| N |
|
|
|
|
ON | T |
| F O |
|
|
| O |
| F |
|
|
| L |
| HI |
| |
|
| IP |
|
|
Selector Switch in Remote
Position (Optional Remote Control)
Figure 36 - Setting the Selector Switch, Control Knob, and Flame Adjustment Knob for Remote Operation
Continued
104325 | 19 |