Vanguard Heating VSGF28PVA Installing Logs, Installation, Continued, Installing Front Log #1

Models: VSGF28PTC VSGF28PVA

1 32
Download 32 pages 63.07 Kb
Page 13
Image 13
INSTALLING LOGS

OWNER’S MANUAL

INSTALLATION

Continued

INSTALLING LOGS

Figure 23 - Installing Front Log (#1) WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

Figure 24 - Installing Middle Log (#2) CAUTION: Do not remove the metal data plates attached to the heater base assembly. The data plates contain important warranty information.

Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Place front log (#1) on top of the grate. Make sure the notches in the bottom of the log fit over the grate prongs (see Figure 35). Push back of log flush with metal grate bar.

2.Rest middle log (#2) behind metal posts on front burner. Make sure the grooves in the bottom of the log fit over the grate (see Figure 36). Bring the log forward next to the metal posts.

3.Slide the grooves in the back of the rear log (#3) against the rear grate prongs. Make sure the peg on the log is on top (see Figure 37).

4.Place the crossover log (#4) on the rear log and the middle log. Make sure the peg on the rear log is in the hole in the bottom of the crossover log. The cross- over log should fit in the cutout of the middle log (see Figure 38).

Front Log (#1)

Notch

Grate

Prongs

Metal Grate Bar

Figure 23 - Installing Front Log (#1)

Middle Log (#2)

GrooveFigure 26 - Installing Crossover Log (#5)

Metal

Post

Groove

Grate

Metal Post

Figure 24 - Installing Middle Log (#2)

Groove

Peg

in Back

of Log

Rear Log

(#3)

 

Grate Prong

 

Rear

 

Burner

Groove

 

in Back

 

of Log

 

Grate

 

Prong

Crossover

Log (#4)

CutoutHole

Figure 27 - Installing Fireplace Screen Peg

Figure 26 - Installing Crossover Log (#5)

Notches

Screws for

Mounting

Screen

Figure 27 - Installing Fireplace Screen

Figure 25 - Installing Rear Log (#3)WARNING: You must operate this fireplace with the fireplace screen in place. Make sure fire- place screen is in place before running fireplace.

5.Install fireplace screen by slipping notches of fireplace screen over screws on front of fireplace (see Figure 39).

Figure 25 - Installing Rear Log (#3)

107156

13

For more information, visit www.desatech.com

Page 13
Image 13
Vanguard Heating VSGF28PVA Installing Logs, Installation, Continued, Installing Front Log #1, Installing Middle Log #2