OWNER’S MANUAL
SAFETY
INFORMATION
Continued
16.Operating fireplace above elevations of 4,500 feet could cause pilot outage.
17.To prevent performance problems, do not use propane/LP fuel tanks of less than 100 lbs. capacity.
18.Provide adequate clearances around air openings.
PRODUCT
IDENTIFICATION
| Crossover | Rear |
Middle Log | Log | |
| Log | |
|
| |
Front Log |
|
|
|
| Rear |
Front |
| Burner |
|
| |
Burner |
|
|
LOCAL CODES
Install and use fireplace with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code ANSI Z223.1/NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
UNPACKING
WARNING: Do not remove the data plates attached to the heater base assembly. The data plates contain important warranty information.
1. | With utility knife, cut the carton all the |
| way around above the staples on the |
| bottom tray. Lift the carton off the |
| heater. Remove packing. Note: The |
| hood is located in the packing on the |
| right hand side of the heater front. Lift |
| the heater off the bottom tray. |
2. | Locate two screws above top corners |
Figure 1 - Log Base Assembly, Split Oak Set
Top Louver
Assembly
Fireplace
Hood
Firebox Support
Screen
Assembly
Figure 2 - Fireplace
Top Outer
Casing
Optional Blower
Assembly
(Not Included)
Bottom
Louver
Assembly
| of the fireplace screen. Remove and |
| discard these screws. Lift fireplace |
| screen up and pull out to remove. |
3. | Remove protective packaging applied to |
| logs, log base assembly, and fireplace. |
4. | Remove fireplace hood from carton |
| insert. |
5. | Check all items for any shipping dam- |
| age. If damaged, promptly inform |
| dealer where you bought fireplace. |
107156 | 3 | For more information, visit www.desatech.com |