Velodyne Acoustics Digital Drive user manual Setup is complete

NOTE: When a DD subwoofer detects an incoming RS-232 command, it reverts to “Slave Mode”. This means that the subwoofer will no longer accept IR commands. To reestablish normal operations, remove the RS-232 cable and power cycle the unit.

Note that the daisy chain connection ONLY allows the woofers to communicate basic “run-time” commands such as volume and preset. We recommend the following sequence when setting up daisy-chained subs.

1.First, connect only the master sub to the system. Do not connect the thru or serial cables at this time.

2.Establish the crossover, phase, and other settings EXCEPT the EQ on the master sub (see setup steps 1 – 17 starting on page 17). Note the low pass crossover, phase and polarity settings, then save.

3.Connect the video out of the slave subwoofer, go to the settings screen, establish the low pass crossover, slope, phase, polarity, and night mode settings from the master subwoofer, then save settings. Repeat for each slave subwoofer in your system.

4.Connect the microphone to the slave subwoofer and use the “self-EQ” feature (described below) to establish room EQ for that subwoofer.

5.Repeat steps 3 and 4 for each slave subwoofer in your system.

6.Reconnect the video out to the master subwoofer, and reconnect the thru and serial cables so that the master and slave subwoofer (s) are daisy chained.

7.EQ the primary subwoofer (see steps 8-25 starting on page 20). Self-EQ is NOT recommended for the primary subwoofer.

8.Setup is complete!

.w w w . v e l o d y n e . c o m Digital Drive User’s Manual

11