SETUP column lock | This setting freezes the SETUP column values. |
| Previously, after individually setting preset values, |
| a change to the setup column would override any |
| individual preset changes. Users are advised to |
| complete the global setup using the setup values, |
| then freeze the setup column and adjust individual |
| presets if desired. |
|
|
Remember previous graph so | This has been implemented by simply not erasing |
that the effect of settings | the previous graph until the new graph overlays it, |
such as phase or crossover | allowing the user to see the effect of the |
can be seen | new settings. |
|
|
Full functionality on graph | Previously, the TEST button showed the user the |
screen when TEST key is | graph screen but the only function was to press |
pressed on settings screen | TEST again to return to the settings screen. Now |
| the graph screen is fully functional, and pressing |
| test again puts the user at the field where they left |
| off on the settings screen. |
|
|
Light blink scheme for | When the volume up or down buttons are pressed, |
volume level | the Velodyne light will blink faster as the volume |
| increases, and slower as the volume decreases. |
|
|
Light blink scheme for | The Velodyne light blinks the number of times for the |
preset selection | preset (e.g. three times for preset three). |
|
|
Accommodate all requested | This was introduced in release 1.6 and has been |
discreet remote codes | carried over to release 2.0. |
|
|
Slave Mode | When two DD subwoofers are connected together |
| via RS232 cable, the slave subwoofer goes into |
| slave mode whereby it ignores remote IR input. |
| To reset from slave mode, power cycle the unit. |
|
|
.w w w . v e l o d y n e . c o m | Digital Drive User’s Manual |
48 |