for a subwoofer is tucked away in a corner of your listening room. This location will usually provide the greatest output levels with optimum low frequency extension. The worst location for a subwoofer it typically far away from any walls, and close to the center of your room. Avoid these locations when possible. When using a pair of Velodyne subwoofers in stereo, it is preferable to place each subwoofer by the satellite of the same channel.
Caution!
This subwoofer has electronics built into the cabinet. Do not place the cabinet next to sources of heat such as furnace registers, radiators, etc. Do not place the unit near sources of excessive moisture, such as evaporative coolers, humidifiers, etc. The power cord should be routed in such a way that it will not be walked on, pinched, or compressed in any way that could result in damaging the insulation or wire.
Regardless of where you install your Velodyne subwoofer, it must remain inanuprightposition(wooferfacingforward).Using,shipping,orotherwise storing the subwoofer in any other position for an extended period of time may result in damage to the unit not covered by warranty.
Certain types of televisions are particularly sensitive to stray magnetic fields. If your television produces distorted colors after installing your subwoofer, simply increase the distance between your television and the subwoofer, until normal color and operation is returned.
Protection Circuitry
Your new subwoofer is equipped with special protection circuitry to providemaximumperformancewithgreatestreliability.
Crossover switch - In/Out
Thisswitchallowstheelectroniccrossovercircuitrytoberemovedfromthe signal path. This is preferable in certain installations which route the signal through external processors with a crossover circuit of their own, such as thenewdigitalunits.SimplymovetheswitchtoOUTtodisengagethebuilt in crossover. For all other installations which do not have a separate electronic crossover we recommend you leave the internal crossover IN to provide optimum performance.
Auto turn on function
With this function in the "auto" position, your subwoofer can be safely left withthemainpowerswitchoncontinuously.Thesubwooferwillturnitself on automatically when an audio signal is present. If no signal is present for approximately 15 minutes, the unit will switch to standby mode. While in standby mode, your subwoofer will draw very minimal power. This function can be disabled by leaving the switch in the "on" position.
Remote sensor
This connection allows for
Detachable power cord
Allows for easy replacement should the original be damaged.
Line-Level Connection
Figure 1 shows connection to a
continued. . .
7 | ☞ | 4 | ☞ |
|
|
|
|
