A Wor d About Subwoofer Placement
Subwoofers operate at extremely low frequencies, which are primarily
Remember that the
Caution!
This amplifier has electronics built into the cabinet. Do not place the amplifier next to sources of heat such as furnace registers, radiators, etc. Likewise, do not place the amplifier near sources of excessive moisture, such as evaporative coolers, humidifiers, etc. The power cord should be routed in such a way that it will not be walked on, pinched or compressed in any way that could result in damaging the insulation or wire.
Selecting the Subwoofer(s) to be Controlled
Your
Model | LED Display | Model | LED Display | |
|
|
|
|
|
SC - 8 | 8 | SC - In - Wall (SC - IW) |
| IW |
SC - 10 | I 0 | SC - In - Floor (SC - IF) |
| I F |
SC - 12 | I 2 | SC - In - Ceiling (SC - IC) |
| I C |
SC - 15 | I 5 | Generic Subwoofer** | GS |
**- The generic subwoofer setting is for passive subwoofers not on the above list. CAUTION: there is no anti- clipping or
To change the subwoofer to be controlled, first power down the amplifier using the power switch on the back | |
panel (DO NOT use the power button on the front panel). Then, turn the switch on while depressing any of | |
the buttons on the front panel (crossover up or down, or volume up or down). The unit will show the model | |
it is currently controlling. To change the model, simply push the crossover up or crossover down buttons and | |
the model changes on the LED display. Once the desired model is seen on the LED display, simply release the | |
button. You don’t need to do anything else - the model to be controlled is automatically stored in the | |
.w w w . v e l o d y n e . c o m | SubContractor User’s Manual 11 |