memory. To exit model selection mode, use the power switch on the back panel to power down and power up the unit. You should see the model you selected for 2 seconds on the LED display before the display reverts to the volume.
Using the SC - 1250 to Drive Two Subwoofers
Once the model selection process is completed, no other adjustments are needed to enable the
U s a g e
This section addresses
Remote Contr ol
The features of the
•POWER — This button forces your
Note: The master power switch on rear panel must be on in order for the front power button to function.
•MUTE — This button mutes the subwoofer. The LED on the amplifier will show 00 if the unit is muted. To unmute the subwoofer, press the MUTE button again and the original
volume setting shows on the LED. | Figure 6: |
•EQ — This button automatically EQs the subwoofer using a 7 band internal graphic equalizer. To use this feature, first plug the supplied microphone into the
Note: Each time the EQ feature is utilized, the EQ settings for the
•PHASE — These buttons allow you to optimize the subwoofer performance for the location and your listening position. Select the switch position at which you hear the most bass. The LED will show the phase selected by showing “PH” followed by the phase number.
•LIGHT — If you wish, you can deactivate the numeric LED on your
.w w w . v e l o d y n e . c o m | SubContractor User’s Manual |
12 |