10
.www.velodyne.com Digital Drive User’s Manual
4.Connect the audio/video cables between your SMS-1(EQ OUTPUT VIDEO/LEFT/RIGHT –
yellow, white, and red respectively) and your electronics (receiver, processor, TV, etc.). Insert
the color-coded cable plugs into the correct EQ OUTPUT receptacle –the yellow plug into the
VIDEO jack, the white plug into the LEFT jack, and the red plug into the RIGHT jack. The
opposite ends of the cables should be connected to your receiver/processor. The yellow
VIDEO cable goes to an available composite video input (e.g. aux), and the white/red AUDIO
(L&R) cables go to a corresponding audio input. As an alternative to composite video, you
may want to use S-video (S-video connector not included). Connect the S-video from the
SMS-1to an S-video compatible input on either your processor or TV. Consult your
receiver/processor and/or TV owner’s manual for more information.
5. Connect your subwoofer(s) to the SMS-1using the XLR connector or LFE out RCA connector.
6. Defeat the crossover on your subwoofer(s) (if possible) and set its volume to the
middle setting.
NOTE: Make sure the audio output goes into your AUDIO system, not your TV! The SMS-1will
generate test tones used to match the SMS-1to your satellites and to correct for room
anomalies that need to be played by your main audio system.
7. Insert the XLR microphone cable’s 3-pin male plug into the MIC INPUT jack (location 7 on
Figure 2) on the front or back panel of the SMS-1.
8. Slide the microphone (male connector end first) down through the open, circular sleeve of
the tabletop microphone stand. Position this assembly at a desired listening position.
NOTE: The Digital Drive Accessory Kit includes a microphone stand adapter (1/2”-27 thread)
for use with professional mounting stands. Be sure to first remove the inner thread piece
(3/8”-16) before using.
9. Connect the XLR microphone cable’sfemale jack end with the male connector end of the
microphone.
10. Sheath the microphone pickup with the foam windscreen cover as a protection against dirt
and airborne contaminants.
A WordAbout Interconnect Cables
When installing your new Velodyne SMS-1using the line level connections, you should always
use shielded phono cables. Therearemany quality cables available today,most any of which
will work perfectly well. We do recommend that you keep the length of cable as short as
possible to avoid any potential noise problems.
A Word About Connecting more than one SMS-1
Note that your SMS-1can control up to three subwoofers. Each of the three subwoofers will
receive the same conditioned signal from the SMS-1. If you wish to run morethen three
subwoofers, or wish to individually customize the signal to different subwoofers, you will need
morethan one SMS-1connected in a “daisy-chain” configuration. This section describes setup
in a daisy-chain configuration.