Velodyne Acoustics SMS -1 user manual Installation Quick Start

Installation – Quick Start

To quickly set up and take advantage of the auto-EQ feature in your new Digital Drive SMS-1, perform the following steps:

1.Unpack the SMS-1 and connect the power cable.

2.Connect an LFE input cable from your receiver/processor to the input jack. For other hookup options, see step 2 on page 9.

3.Connect a high quality line level cable from one of the LFE out jacks to your subwoofer.

4.Disable your subwoofer’s crossover if possible, and set its volume to one-quarter up to one-half setting.

5.Power up the unit and ensure that it is receiving and processing signal from your receiver (i.e. your subwoofer is playing bass).

6.Connect the microphone (found in the accessory kit) to the XLR mic input jack on the front or rear panel of the SMS-1 and place the mic in your favorite listening position.

7.Press 3-2-1 on the remote.

8.The subwoofer should emit 25 “sweep” tones then restart and play normally. NOTE: If you have the video connected you will see the sweep screen with Self-EQ mode indicated. This screen will show the EQ adjustments as they happen.

9.Adjust the SMS-1’s volume and your subwoofer’s volume to taste.

10.Enjoy your room-equalized sub!

.w w w . v e l o d y n e . c o m Digital Drive User’s Manual

8