Venmar ESC270, QDE, ESB10 manual Prepare the Installation, Prepare the Hood

3. PREPARE THE INSTALLATION

Make sure the following items are included:

-Hood

-Filters (2)

-Adapter/damper assembly 3¼’’ x 10’’ (located inside the hood, under the bottom panel)

-Compact fluorescent lamps (120 V, 13 W, PLC13, 2700 K with G24q-1 base) (packed behind the light diffuser)

-Parts bag (located inside the hood, under the bottom panel) including:

1 wire clamp, 5 no. 8 x 1/2’’ double thread screws, 2 wire connectors and 6 no. 6 x 1/2’’ screws

Part sold separately:

- Transition 3¼”x 10” to 6” round (optional, for 6” round ducts installation only)

CAUTION

When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses and gloves.

NOTE: If the bottom of the cupboard is recessed, attach wood strips (not included), as shown beside, in order to properly install the range hood under the cabinet. The wood strips must be as thick as recess.

23 8 ”

HO0002A

Cut-out the openings for duct (A) and power cable (B), in cabinet or wall, according to the direction of discharge chosen.

See figures below.

HORIZONTAL DISCHARGE:

C
	L
A	111 8”
3½”		7 8”
5¼”	5¼”	B
		1¼” dia.
HD0150A

VERTICAL DISCHARGE:

CABINET BOTTOM

		C
		L
	A	10½”
	3¾”	1¼”
					1½”
HD0151A	5¼”	5¼”	3 8	”	B
	¾”

4. PREPARE THE HOOD

Remove both filters from the hood. Disassemble the adapter/damper (A) from the hood.

NOTE: The adapter/damper is located inside the hood. Remove the bottom panel (B) to access the adapter/damper. Refer to figure beside.

A

HO0091 B

- 5 -