Instructions, Operation and Directions for Use — continued
Cold Protection Mode
When the “Information Display” is displaying “CP”, the device has been exposed to temperatures below
Heat Protection Mode
Note: Consecutive uses and high ambient temperatures can cause the Treatment Head surface to become hot. The device monitors the Treatment Head surface temperature during each treatment cycle to ensure that the Treatment Head maintains an optimum temperature. If the device exceeds the optimum temperature limit, it will enter Heat Protection Mode and device will limit operation until sufficient surface cooling has been achieved.
When the “Information Display” is displaying “HP” the device has reached or exceeded its optimum temperature limit and will not continue to operate until a cool down period has been completed.
If your device enters Heat Protection Mode:
The “Information Display” will display “HP” and the device will beep 10 times and immediately terminate the treatment cycle.
Step 1: Set the device back on the Charging Stand and allow cooling.
Step 2: Once “HP” is no longer visible in the Information display, the device is ready for use.
Step 3: Resume normal operation as outlined on page 18 of this manual.
Note: Heat protection mode can be avoided by allowing the unit a short cool down period between treatment cycles.
An additional head may be purchased and interchanged if many consecutive treatments are required on a regular basis.
22
