Step 1
Step 2
Step 3
Step 4
Step 5
Operating Instructions
Proper Use Operations
Note:
•For best results, remove all
•During use, hold the device in a single location until the cycle is complete.
Step 1: To ACTIVATE, press the Power Button until the device beeps once, indicating that the care cycle is ready to begin.
Step 2: Apply protective eyewear (goggles). Place over cotton balls for added comfort.
Step 3: To START, place the device against the desired area of your skin to receive care. The LED lights will turn on and the cycle will begin once the device is in full contact with your skin.
Step 4: Hold device firmly in place until the device beeps twice signaling that the care cycle is complete. Do not move the position of the device on your skin. Device will beep if removed from skin — see page 10. If battery runs low and shuts off unit, plug AC Adapter directly into device and continue care cycle.
Step 5: Replace the ClearWave® Soothing Skin System to the Charging Stand to fully charge for the next treatment.
Note: To manually turn OFF the ClearWave Soothing Skin System prior to the end of a cycle, press and hold the Power Button for approximately 3 seconds until the device beeps twice.
Note: Device can be used when connected directly to the AC Adapter. See page 11.
Daily Care for Your Skin
The daily care regimen is the same for both interchangeable heads. When using the ClearWave Soothing Skin System, care for each desired area of the skin for the 3 minute cycle. You may care for a particular area up to a maximum of 15 minutes (5 cycles) in a 24 hour period. For optimal results, allow 24 hours before your next care cycle.
9
Job#: XXXXXXX Title: CWST2RB Manual
Date: 10/15/09 Version:
