Replacing the Interchangeable Heads
Blemish Head
• 414nm of blue light soothes inflamed pores to help restore your skin to a healthy glow.
Fine Lines and Wrinkles Head
•660nm of red light helps to eliminate pimples and blemishes and fine lines and wrinkles deep in the skin.
Push and release
latch buttons
To Remove the Interchangeable Head:
Step 1: Press and hold both Head Latch Buttons
shown on each side of the Head.
Step 2: Separate the Interchangeable Head from the Device Body.
To Install an Interchangeable Head:
Step 1: Align the three round plastic posts on the back of the Interchangable Head with the three post sockets on the Device Body.
This will also align the square latch holes on the interchangeable head with the Head Latch buttons on the Device Body.
Step 2: Press and hold both Head Latch Buttons on each side of the Head.
Step 3: Press the Head into place against the Device Body and release the Head Latch Buttons.
Step 4: Press Power Button for approximately one second to activate Status Mode (see page 7). The Information Display should now display the amount of cycles remaining on the new Interchangeable Head.
Note: If the Information Display shows three dashed lines
Note: The device monitors each care cycle to ensure that the Interchangeable Head is delivering a complete and effective dose. Once the LEDs have passed their guaranteed 100% output life where a complete dose cannot be guaranteed, the Interchangeable Head will expire and the device will cease to function until the Interchangeable Head is replaced.
The amount of care cycles remaining on an Interchangeable Head is displayed both on the device’s Information Display and on the Interchangeable Head Life Indicator. When the bottom Interchangeable Head Life Indicator Light is flashing and the Information Display is displaying “0”, the head needs to be replaced.
Replacement heads can be ordered directly from Verilux® by calling
13
Job#: XXXXXXX | Title: CWST2RB Manual |
Date: 10/15/09 | Version: |
|
|