Verilux VA06 manual Using the Snooze Feature, Troubleshooting

Using the Snooze Feature

The SNOOZE feature behaves differently, depending on when in the alarm cycle you press the SNOOZE button on top of the Rise & Shine:

If you press SNOOZE after the wake-up light goes on (15 or 30 minutes before the wake-up If you press SNOOZE five minutes or time, depending on what you’ve programmed) less earlier than the alarm time you but before the wake-up audio starts (five have programmed:minutes before the wake-up time you have programmed):

	Sound	Light
Timing	Responses	Responses
immediately	stays off	goes off
five minutes later	stays off	starts at a low level and
		begins a 15-minute cycle
		during which it builds in
		intensity until it reaches the
		maximum brightness you
		have programmed
five minutes before the	starts at low volume and	continues 15-minute cycle
programmed wake-up	builds progressively to the
time	wake-up level you have
	programmed
at wake-up time	at full volume you have	continues 15-minute cycle
	programmed. (Will play for
	one hour or until you turn it
	off, whichever comes first.)
20 minutes after you	continues to play at	reaches maximum intensity
pressed SNOOZE	full volume you have	you have programmed
	programmed (unless you've
	turned it off).
immediately	goes off	goes off
five minutes later	begins at low volume	starts at a low level and
		begins a 15-minute cycle
		during which it builds in
		intensity until it reaches the
		maximum brightness you
		have programmed
10 minutes later	has increased in intensity	continues 15-minute cycle
	and is now at the
	full volume you have
	programmed
20 minutes later	continues to play at	reaches maximum intensity
	full volume you have	you have programmed
	programmed for one hour
	or until you tune it off,
	whichever comes first

	Troubleshooting
Problem	Solution
The device is not working correctly.	Unplug from power, wait 30 seconds, then plug in again. If this is unsuccessful, try
	resetting the unit. See instructions on page 10.
	NOTE: Resetting the unit will require you to reprogram it as well.
When I program the alarm or sleep	Install new or fully charged batteries and reprogram the alarm and sleep cycles, or
cycle using the back-up batteries	program them with the Rise & Shine plugged into the wall outlet.
as the power source and later use
the AC adapter to plug the unit into
a wall outlet, the alarm and sleep
cycles do not function properly.
	14