Assembly Instructions — continued
5. Attach the ballast to the power cord. Use care to align the
6. Plug the ballast into a standard 120V |
|
50/60Hz outlet and turn the lamp on. The |
|
green LED indicator (J) on center of the | J |
ballast will illuminate (Fig. 6). If not, please | |
refer to the troubleshooting section of this |
|
manual (see page 11). |
|
Note: Green LED indicator will not illuminate if lamp is turned off or bulb is removed.
WARNING: Do not block vents on the ballast. Vents are necessary for proper function of the ballast; blocking them may cause overheating of the ballast and increase the risk of fire.
Fig. 5
Fig. 6
AVERTISSEMENT : Ne pas bloquer les ouvertures sur le ballast. Vents sont nécessaires pour le bon fonctionnement du ballast, le blocage entre eux peuvent provoquer une surchauffe du ballast et d’accroître le risque d'incendie.
ATTENTION!
ALWAYS lift your | DO NOT lift the lamp |
lamp by the shaft | by the gooseneck |
9