CAUTION
Do not overtighten.
Overtightening could strip the screw holes.
Do not operate the cleaner without the screw in place.
Using a screwdriver,
tighten the screw,
CORD ASSEMBLY
Make sure the quick release cord hook is in
the upright position, Remove the wire tie
from the power cord.
Lock the cord into
place by forcing | it |
| |
into the locking |
|
| |
notch on the body |
| ||
of the quick | Notch |
| |
|
| ||
release cord hook |
| ||
as shown° This |
|
| |
helps keep the |
|
| |
power cord out |
|
| |
from under the |
|
| |
vacuum cleaner |
|
| |
agitator, |
|
| |
| Wrap the | ||
| power cord | ||
| around the | ||
Quick Release | quick release | ||
cord hook | |||
Cord | |||
| and lower | ||
Power | cord | retainer, | |
then | lock the | ||
| |||
power cord
Lower Cord | plug onto the | |
Retainer.,.. | ||
power cord. | ||
|
ATTACHMENT
ASSEMBLY
After the handle has been assembled to the body and the power cord has been wrapped around the cord hooks, the attachments can be assembled.
1.Snap the suction inlet end of the hose into the back of the vacuum cleaner.
2.Place the hose behind the handle and over the hose holder_
3.Place the hose in the front slot of the tool holder, twisting and pushing down over the short hose to assure a good connection.
4.Place the extension wand in the rear slot of the tool holder,
5.Slide the crevice tool into the slot beside the wand.
6.Place the dusting brush or combination brush on the wand with the brush portion up.
Handle]
Hose
HoMer
Dusting
Brush
Extension
Wand
®
Suction
InletTool
Tool
Holdei
Hose
