2.Hold the burner at the right hand side and lift to clear the right burner leg. Then pull to the right to clear the injectors on the left hand side.
3.Turn burner upside down and remove air shutter. Turn air shutter upside down and replace on burner. (Fig. 13)
4.Replace burner. Slide the burner in at an angle with left side lower than the right side. Slide the left side onto the injectors, making sure the burner leg remains at a 90° angle to the base. (Fig. 14) Lower the right hand side down in to place. Make sure the burner is as far left as possible and the injector shoulders are inside the burner.
Air Shutter as Shipped from Factory |
Bottom of Burner Pan |
Air Shutter Turned Upside Down |
ST667 |
Fig. 13 Remove air shutter, turn upside down and replace.
Left Burner Leg |
Injector Orifices |
90° |
ST353a
Fig. 14 Be sure injector orifices remain at 90° to the base.
5.Replace rear, left and right log bracket assembly and replace logs.
UVS27
6.Slide the catalyst through the grille opening. Set catalyst on top of firebox. Secure with two (2) screws and washers. (Fig. 15)
7.Shoulder bolts provided in catalyst kit must be in- stalled on top of firebox. Use nut to secure in place. (Fig. 15)
8.Install glass frame assembly by resting the bottom edge of the frame on support brackets below the front opening of the firebox. Rotate the top edge of the assembly toward the firebox, and center it. Fas- ten by “rotating” the cams over the top left and right edges of the frame. (Fig. 16)
Shoulder
Bolts
Catalytic Combustor
NOTE: Shown with top |
|
removed for clarification. | ST709 |
Fig. 15 Install shoulder bolts and set catalytic combustor in | |
place. |
|
NOTE: Shown with top |
|
removed for clarification. | ST711 |
Fig. 16 Rotate cams into place to hold glass frame assembly in place.
20007068 | 11 |