Vermont Casting 4030 - 4049 manual Assembly Procedures, Unpack the Stove, Install Optional Fan Kit

Models: 4030 - 4049

1 28
Download 28 pages 60.69 Kb
Page 9
Image 9
Assembly Procedures

UVS27 Vent-Free Gas Heater

Assembly Procedures

Unpack the Stove

The UVS27 is shipped fully assembled on its back. Unpack the stove and carefully set it upright.

CAUTION

Porcelain enamelled surfaces are fragile. Handle porcelain enamelled castings tenderly. Familiarize yourself with the assembly steps before you begin and proceed with deliberation and care. If possible, have assistance available.

Place enamelled castings on a soft, cushioned sur- face until you are ready to assembly.

Avoid contact between the castings and other hard surfaces or objects.

Install Optional Fan Kit

1.Remove shroud assembly by loosening two (2) hex head bolts on lower inside of shroud. Lift shroud as- sembly up and away from stove.

2.Attach the fan to the rear shroud by engaging the upper flange of the fan skirt under the lower edge of the shroud and secure the skirt with the four screws and one star washer provided. (Figs. 4, 5)

Upper

Flange

ST344a

Fig. 4 Place upper flange behind lower edge of shroud.

ST345a

Fig. 5 Correct position of fan skirt installation.

3.Feed the snapstat wire lead up between the inner and outer rear shroud panels and secure the snapstat to the upper right side of the inner shroud. (Fig. 6)

4.Secure the snapstat wire harness to the shroud panel using the wire tie provided.

5.Replace shroud and tighten the two (2) hex head nuts on lower inside of shroud.

6.Route the rheostat control switch and wire forward under the stove. Use the wire tie to secure the fan and rheostat wire harnesses together to the tubing under the bottom heat shield.

7.Install the rheostat onto the bracket to the left of the valve. (Fig. 7)

 

 

ST346a

Fig. 6 Attach snapstat to inner shroud.

 

 

Retaining Nut

Rheostat

 

Control Knob

 

FK104

Fig. 7 Attach rheostat to bracket.

MOTOR

 

BLK

BLK

BLK

 

 

 

BLK

SNAPSTAT

 

WHT

WHT

GRN

ON/OFF

RHEOSTAT

 

 

ST236

Fig. 8 Fan wiring diagram.

WARNING

Failure to position the parts in accordance with these diagrams, or failure to use only parts specifically ap- proved with this heater may result in property dam- age or personal injury.

20007068

9

Page 9
Image 9
Vermont Casting 4030 - 4049 Assembly Procedures, Unpack the Stove, Install Optional Fan Kit, UVS27 Vent-FreeGas Heater