Vermont Casting 6100 owner manual Assembly Attach the Base to the Pillar, Tools Needed

Assembly Step 2 - Attach the Base to the Pillar

Tools Needed:	locking
	caster

3/8”

wrench

7/16”

wrench

back side of base,

upside down

USE HARDWARE BAG A :

1/4-20 hex

nut (4)

1/4-20 x 3/4”

bolt (4)

LOCATE THESE PARTS:

pillar

assembly (1)

base assembly (1)

locking casters

back side of pillar,

upside down

1.Lock the pre-assembled casters on base by pushing down on the latch.

2.Set the pillar upside down.

3.Set the base upside down onto the pillar bottom as shown, aligning the holes in the base with holes in the pillar.

4.Insert the four bolts through the holes in the pillar and base. Thread the locking hex nuts onto bolts. Tighten the bolts and nuts with the wrenches.

5.Carefully turn the assembly upright onto the casters.

11