Vermont Casting BREF36R/42R manual Cleaning Trim, Replacing Light Bulbs, BREF Electric Fireplace

BREF Electric Fireplace

8.Place the right front log (G5) in position on the ember lava rock. Use the notches under the log front right to have a proper location.

G2 G1

	G3	G5
G4		LG324

Fig. 7 BREF42/BREF42R ceramic log placement.

To reduce the risk of fire, electrical shock or personal injury, disconnect all power coming to the fireplace at the main service panel before attempting any maintenance or cleaning.

Cleaning Trim

Clean the trim using a soft cloth you have slightly damp- ened with lemon oil; then buff with a clean soft cloth.

NOTE: You can obtain lemon oil at super-markets and hardware stores. Do not use commercially made brass polish or household cleaners, as these products will damage the trim.

Replacing Light Bulbs

This fireplace uses four (4) clear, 120 Volt, 60 Watt, E-12 socket base (small base, chandelier candle-type) light bulbs. These lights are located under the ember bed of the unit.

Do not exceed 60 Watts per bulb. Use of higher-rated bulbs may result in fire, caus-

ing property damage, personal injury, or loss of life.

NOTE: For the sake of convenience, you may wish to consider replacing all the light bulbs if one of them burns out.

1.Turn OFF the power to the unit at the main service panel.

2.If the fireplace has been operating, allow it to cool.

3.Open glass (if applicable); open steel curtain.

4.Remove the log. Remove the two (2) screws, one on each side of the ember bed/plate support log set down. Remove the ember bed/plate support log set.

5.Examine the bulbs to determine which one(s) need to be replaced (if you are not going to replace all).

7.Install new light bulb(s) by screwing in while holding the socket.

8.Reinstall the ember bed, log set, glass door, and steel curtain.

10 10004758