Vermont Casting BREF30, BREF36, BREF42 Operating Instructions, 1. ON/OFF Switch, Heater Control

BREF Electric Fireplace

Operating Instructions

For units with ceramic log sets. (Figs. 6 & 7)

This set of instructions applies to units with ceramic log sets. (Figs. 6 & 7) The control compartment is located inside the fireplace behind the steel curtain near the left front corner. To access the controls, simply slide the steel curtain open.

Control Panel

1. ON/OFF Switch 3. Learn

FP1451a 2. Heater Control 4. ON/OFF

Fig. 12 Control panel.

1. ON/OFF Switch

The ON/OFF switch is for supplying power to light ef- fects of the fireplace. This switch is normally illuminated to indicate there is electrical power to the unit.

2. Heater Control

The heater control acts to turn the heater ON and OFF, as well as setting the comfort level in the room.

Turn the knob clockwise form the "OFF" position to place the heater into operation. The further the knob is rotated clockwise, the higher the set point temperature.

Turn the knob counterclockwise to lower the set point temperature. Turn it all the way counterclockwise to turn the heater function OFF.

3. Relearn

The BREF36R and BREF42R fireplaces with integral remote control have pre-programmed, matched-pair receiver/transmitters already set with randomly selected house codes. It is highly unlikely that the fireplace code will ever need to be relearned. If the fireplace needs to relearn receiver/transmitter house codes, perform the following steps:

1.Be sure there is power to the fireplace.

2.Be sure there is a good battery in the transmitter (hand-held remote).

3.Open the battery compartment of the remote.

4.Press and release the small button located in the top left corner. This will randomly select a new house code in the remote transmitter.

5.Close the remote transmitter battery compartment.

6.Press either the ON or OFF button on the remote transmitter, and the Learn button on the fireplace at the same time. The fireplace is now ready to accept commands from the remote transmitter.

4. ON/OFF

The ON/OFF button on the fireplace (below the Learn button) is to turn the fireplace ON and OFF when the battery in remote transmitter is weak, or to manually operate the fireplace without the remote transmitter.

NOTE: The device complies with Part 15 of the FCC Rules. Operation is subject to the following two condition:

1.This device may not cause harmful interference, and

2.This device must accept any interference re- ceived, including interferences that may cause undesired operation.

10004758 15