Vermont Casting DVRS3, DVRSL, DVRSR Glass Cleaning, Ceramic Refractory Installation

GLASS CLEANING

It will be necessary to clean the glass periodically. During start-up condensation, which is normal, forms on the inside of the glass and causes lint, dust and other airborne particles to cling to the glass surface. Also initial paint curing may deposit a slight film on the glass. It is therefore recommended that the glass be cleaned two or three times with a non-ammonia household cleaner and warm water (we recommend gas fireplace glass cleaner). After that the glass should be cleaned two or three times during each heating season depending on the circustances present.

Clean glass after first two weeks of operation.

CERAMIC REFRACTORY INSTALLATION

DVRS3 (Fig. 66)

Rear refractory is already installed from factory.

1 . Unpack ceramic refractory from its carton. HANDLE REFRACTORY CAREFULLY.

2.Place bottom refractory manifold side onto fireplace floor and slide under rear refractory.

3.Place bottom sides onto fireplace floor.

4.Place bottom end refractory onto fireplace floor.

REAR

REFRACTORY

BOTTOM

REFRACTORY

MANIFOLD SIDE

BOTTOM SIDE

REFRACTORY

BOTTOM SIDE

REFRACTORY

BOTTOM END	Fig. 66
REFRACTORY

DVRSL/DVRSR Fig. 67

Rear and side refractory are already installed from factory.

1 . Unpack ceramic refractory from its carton. HANDLE REFRACTORY CAREFULLY.

2.Place bottom rear refractory manifold side onto fire- place floor and slide under rear refractory.

3.Place bottom side refractory onto fireplace floor.

4.Place bottom end refractory onto fireplace floor.

REAR

SIDEREFRACTORY REFRACTORY

BOTTOM

REFRACTORY

MANIFOLD SIDE

BOTTOM END	BOTTOM SIDE
	REFRACTORY
REFRACTORY	Fig. 67

- 28 -