Small Cast Profile Surround
Models: CAPCB, CAPEB
Read these instructions before beginning the instal- lation.
CAUTION: Always place castings on a flat protected work surface, such as a towel, blanket or carpet.
These instructions are for the assembly and installation of the Small Cast Profile Surround to the Montpelier Insert.
Carefully unpack and inspect all components from the shipping box. Report any missing or damaged parts to your dealer immediately. Install trim kit after all other insert installation work has been completed, thoroughly checked and tested for proper operation, leaks and installation requirements.
Tools required: Tape measure.
Surround Parts
Column Right Assembly Column, right
Boot, right Slider clip, right
Bracket, On/Off switch (not used on Montpelier Insert)
Column Left Assembly Column, left
Boot, left Slider clip, left
Key
Upper mounting bracket
Upper mounting bracket R (not used on Montpelier Insert) Hardware Bag
Assembly Instructions
1.Place the key on your work surface with the thread- ed holes facing up.
2.Place the column right assembly onto the key. (Fig. 4)
3.Place the column left assembly onto key. (Fig. 5)
Key
Column Right
Assembly
KT424
Fig. 4 Place column right assembly onto key.
Key
Column Left
Assembly
KT425
Fig. 5 Place column left assembly onto key.
4.Install the upper mounting bracket. Use the upper mounting without the marked “R” stamped on the face. (Fig. 6)
5.Fasten the upper mounting bracket to the key with a
4 | 30004451 |