B. Install the Burner/Pan Assembly
The burner/pan assembly is shipped ready for
•Remove the existing cap or gas jet assembly from the gas stub in your fireplace. Clean the threads using a wire brush or steel wool. Apply Teflon tape or pipe dope to the steel fitting and attach the provided brass adapter to the stub.
•Place the burner/pan assembly in the fireplace. The pan should be centered both front to back and side to side.
•Bend the provided gas connector to facilitate its installation between the burner and the gas stub.
•Attach one end of the gas connector to the brass elbow or safety pilot fitting. Attach the other end to the brass adapter at the gas tube.
C. Grate
•The grate, supplied with the firebox will be centered within the firebox. Refer to Figure 4.2.
Figure 4.2 Center Grate Over Burner Pan
D. Place Sand and Rockwool
•Pour the sand into the burner pan. Sand should follow the slope of pan, covering it and the burner tube completely.
•Allow the sand to spill out the front of the pan and over the sides onto the fireplace floor.
•Lightly place
•The gas burns at the point of the least resistance. In case of an uneven flame pattern it may be necessary to adjust the materials in the pans (using an object such as a long screwdriver) to achieve the desired effect.
WARNING
Explosion Risk
•Follow rockwool placement instructions in this manual.
•Replace rockwool material annually.
Improperly placed rockwool interferes with proper burner operation.
Note: For best results, do not pack down the rock wool. The placement of rock wool can have an effect on flame pattern and may need to be adjusted to achieve a desired appearance.
20012914 7/05 Rev. 0
10