ODGSR Series Outdoor Gas Fireplace
Remote Wall Switch
NOTE: Use an approved outdoor switch.
1.Thread wire through the low voltage wire access hole located on either side of unit. Do not cut wire or insu- lation on metal edges. Ensure that wire is protected. Run the other end to a conveniently located wall receptacle box.
2.Attach wire to switch and install switch into receptacle box. Attach cover plate to switch.
3.Connect wiring to gas valve. Refer to Figure 9.
CAUTION: Do not wire millivolt remote wall switch for gas appliance to a 120v power supply.
For lighting instructions, refer to Page 11.
Pilot
Thermodisk
NOTE: If glass doors are installed, the unit must be operated with the doors fully open. (Fig. 10) If the doors are not fully open, the thermodisk will auto- matically turn the unit off.
CAUTION: After the unit cools, the burner will automatically come on.
OPEN
CorrectWrong
Fig. 10 Correct door position during operation.
On/Off
Switch
Fig. 9 Remote switch wiring.
TPTH TP TH
Valve
HV105
8 | 20007114 |
