Vermont Casting R18CFL, R30CFL, R24CFL manual Installation Precautions

Models: R24CFL R18CFL R30CFL

1 14
Download 14 pages 1.86 Kb
Page 2
Image 2
INSTALLATION PRECAUTIONS

WARNING

Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Read these directions thoroughly before installation. For assistance or additional infor- mation, consult your gas log dealer, qualified installer, service agency or

gas supplier.

WARNING

Do not use this appliance or any part that has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

WARNING

If not installed, operated, and maintained in accordance with the manufacturer’s instruc- tions, this product could expose you to sub- stances in fuel or fuel combustion which are known to the state of California to cause cancer, birth defects, or other reproductive harm.

WARNING

A properly sized, unobstructed chimney will normally vent all fumes and products of combustion. Any odor or smoke detected in the room is an indication that the flue is not properly removing the combustion products. Turn off the gas supply valve immediately! The cause of the venting prob- lem must be discovered and corrected before using this gas log set. Disregarding this warning can cause illness as well as soot damage to your fireplace, room, and furnishings.

WARNING

Young children are not allowed to operate this unit and must be supervised when they are in the same room as the appliance.

INSTALLATION PRECAUTIONS

Fireplace damper MUST be locked fully open when operating the gas log set.

If the fireplace has glass doors, operate gas log set only with doors fully opened. The fire- place screen must be in place when the appliance is operating and, unless other provisions for combustion air are provided, the screen shall have an opening(s) for introduction of combustion air.

The log set and its individual shut-off valve MUST be isolated from the gas supply piping system by closing its individual shut-off valve during any pressure testing of gas supply at test pressures equal to or less than 1/2 psig.

The log set and its individual shut-off valve MUST be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of 1/2 psig.

Keep the gas log set clear and free from combustible materials, gasoline and other flammable vapors and liquids.

2

20003889

Page 2
Image 2
Vermont Casting R18CFL, R30CFL, R24CFL manual Installation Precautions