Vermont Casting R24CFL, R30CFL, R18CFL manual Leak Test Procedures, Adding Pan Material, b

Figure 5b CFM159

Figure 5c CFM150

Leak Test Procedures

Create a mixture of equal parts soap and water. Apply to all the joints of the pipe fittings from the gas supply pipe to the burner. Turn on the gas supply valve for no longer than 3-5 seconds. If bubbles appear in the soap solution applied to the joints, there is a leak. Turn off the gas supply valve and tighten those fittings. Repeat the above procedure until no bubbles appear in the soap solution. Remember to test all joints.

WARNING: Do not use an open flame to test for leaks!

NOTE: Always perform a leak test any time the appliance has been moved or disconnected from the gas supply line.

Adding Pan Material

1.Open the bag of Silica Sand and spread it evenly across the Burner Pan, to the top, as shown in Figure 6. You may overflow the front and sides of the pan to cover the entire pan and connecting hardware. NOTE: Sand is for use with Natural Gas ONLY! Vermiculite or Lava Rock must be used in place of Sand for Propane Gas. See Propane Conversion Kit Manual for details.

2.Next, open the bag of Glowing Embers and place them on top of the Silica Sand, evenly across the Burner Pan. Be sure to separate the Glowing Embers into very small pieces before placing them onto the Silica Sand.

20003889

	Glowing
	Embers
	Silica
	Sand
	Glowing
	Embers
	Lava Rock
Figure 6	LG370
	7