Vermont Casting WOOD STOVE owner manual CFM Corporation

CFM Corporation

Part No S19035 Rev10

NOTE: Retain this sheet for future reference

Model No. S170 / S170P

This unit has been listed by Warnock Hersey Limited to meet or exceed CSA B 366, 2M and ULC S-627 Canada

A minimum clearance of 18” (457mm) to the chimney connector may be required by the authority having jurisdiction.

6” Flue Required

Figure A: Clearance from combustible constructions

From Heater From Chimney Connector

A Sidewall	18” (457 mm)
B Backwall	10” (254 mm)
C Corner	11” (279 mm)

D Sidewall	29” (737 mm)
E Backwall	12-1/2” (318 mm)
F Corner	21-1/2 (546 mm)
G Ceiling	54” (1372 mm)

2FT(635mm) HIGHER

THAN NEAREST

POINT OF ROOF

WITHIN 1OFT(3m)

MINIMUM OVERALL HEIGHT FROM FLOOR 15FT(5M)

3FT(1M) MIN	Contact your local building inspector
FROM ROOF	prior to installation.
PENETRATION	A permit may be required in your area.

	BACK WALL		BACK WALL
8”	B	E	C
		SIDE WALL	F
SIDEWALL	A
G
	D	18”
			C
			F
	8”	8”
		Figure “A”

Unit must be placed on a noncombustible floor protection equivalent to 3/8”(9.5mm) millboard extending 18” (457mm) in front and 8” (203mm) to side and back of unit per manufacturer’s instructions.

Consult your local building authorities for further information.

HANDLE

Twist spring handle SPRING in counter clockwise motion while pushing on to handle; spring handle will “thread” down to desired location.

CAUTION: Do not open fire-door to a point where it would be in contact with the combustible sidewall.

OPTIONAL FAN

An optional heat exchange blower is available for this wood burning appliance. To order please see the local dealer where you purchased your appliance.

MADE IN CANADA BY CFM CORPORATION,410 ADMIRAL BOULEVARD, MISSISSAUGA, ON L5T 2N6 1