Installation Instructions
ENGLISH
ELECTRICAL SUPPLY
Before installing the oven have a qualified electrician verify that your home is provided with adequate electrical service and that the addition of the oven will not overload the branch circuit on which it is to be installed.
Aseparate
NOTE: FOR USE WITH 208 V, 60 HZ SUPPLY VOLTAGE, SEE CONNECTING TO 208 VOLT CIRCUIT.
For
Location of rating plate
CONNECTING TO 208 VOLT CIRCUIT
This option is provided for areas where standard 240 Volt service is not available. This option must be accessed with the oven connected to power source, and using the following sequence:
1.Within five minutes from power up, hold [OPTIONS] and [TIME] keys for 3 seconds to enter the user option menu. The display shows as follows:
2.Hold then [TIME] and [LIGHT] keys until the display becomes dark.
3.Hold [OPTIONS] and [LIGHT] further, until the time display shows “Volt” and temperature module shows “240” blinking, waiting for an input.
4.Using [INC] or [DEC] keys, the control toggles between 240V and 208V options. Hold “OPTIONS” to confirm.
5.Hold [TIME] and [LIGHT] keys in order to quit the selection.
6.Hold [OPTIONS] key for 3 seconds to quit the user option menu.
WIRING REQUIREMENTS
When making the wire connections, use the entire length of the conduit provided (3 feet). The conduit must not be cut.
Before making connections make sure the power is off and read and observe the following:
1.A separate
2.The oven must be connected with Copper or Aluminum wire.
3.In the United States:
Wiring must conform to the National Electrical Code, ANSI/NFPA No. 7 latest edition. You can obtain a copy of the National Electrical Code by writing to: National Fire Protection Association Batterymarch Park Quincy, MA 02269
In Canada:
Wiring must conform to Canadian Electrical Code C22.1- latest edition. You can obtain a copy of the Canadian Electrical Code by writing to: Canadian Standards Association 178 Rexdale Boulevard Rexdale (Toronto), Ontario, Canada M9W 1R3
4.Wire size (Copper or Aluminum wire) and connections must be suitable for the rating of the appliance as per the National Electrical Code requirements. The flexible armoured cable extending from the oven should be connected directly to the junction box.
5.The junction box should be located so as to allow as much slack as possible between the junction box and the oven so it can be moved if servicing is ever required.
6.A U.L. listed conduit connector must be provided at each end of the power supply cable.
The voltage setting is stored and kept even after a long
WARNING
ELECTRICAL SHOCK HAZARD
The electrical power to the oven branch circuit must be shut off while line connections are being made.
Do not use an extension cord with this appliance.
Electrical ground is required on this appliance. The free end of the green wire (the ground wire) must be connected to a suitable ground. This wire must remain grounded to the oven.
If cold water pipe is interrupted by plastic, non metallic gaskets, union connections or other insulating materials, DO NOT use for grounding.
DO NOT ground to a gas pipe.
DO NOT have a fuse in the NEUTRAL or GROUNDING circuit. A fuse in the NEUTRAL or GROUNDING circuit could result in an electrical shock.
Check with a qualified electrician if you are in doubt as to whether the appliance is properly grounded.
Failure to follow these instructions could result in serious injury or death.
CAUTION
Do not repair or replace any part of the appliance unless specifically recommended in the manual. All other servicing should be done by a qualified technician. This may reduce the risk of personal injury and damage to the oven.
Never modify or alter the construction of the appliance by removing panels, wire covers, screws, or any other part of the product.
7
