HOW TO REPLACE THE CROSS FADER
●Remove four screws, which hold the fader unit panel.
●Remove the cross fader unit,
●Carefully remove the
●Insert the connector to the new fader unit.
Remove the
+ | + |
+ | + |
Remove four screws.
MICROPHONE SECTION
17 18 19
MONITOR SECTION
20 21 22 23
○17 INPUT (Mic Input Jack)
Input jack for the microphone.
○18 LEVEL (Mic Level Volume)
Adjusts the input level of the microphone.
○19 FILTER (Mic Filter Volume)
Adjusts the cut off frequency of the microphone input. It is used to prevent low frequency noise such as breathing, vibration, etc.
○20 CUE SELECTOR
Used to select the cue signal to be monitored by headphones from PGM1, PGM2 or AUX.
○21 STEREO CUE (Stereo Cue ON/OFF Switch)
When this switch is set to ON, the input signal selected by CUE SELECTOR can be monitored in stereo through headphones. When this switch is set to OFF, the master signal can be monitored through the right side of the headphone all the time, the CUE signal selected by CUE SELECTOR will be heard from the left side. This feature allows DJs to monitor current and next source simultaneously.
○22 LEVEL (Headphone Level)
Adjust the monitor level of the headphones.
○23 PHONES (Headphone Jack)
Used to connect the headphones. Headphones with impedance from 8~600 can be used.
6