Sharp AR-507 Disabling of Auto Power Shut-off Mode, Disabling of Beep When Keys Touched

KEY OPERATOR PROGRAMS

To require key operator code entry for access to key operator programs, press the check box of “DISABLING OF PC/ MODEM ACCESS.” to display a check mark in the check box. To permit remote access to key operator programs without key operator code entry, press the check box of this program again to clear the check mark in the check box.

NOTE:

The customers must choose the setting of this program by themselves. If this program is not set, external operators can access the key operator programs from a computer or other equipment without key operator code entry. If this program is set, external operators must enter the key operator code to access the key operator programs. (This program is set in the factory default setting.)

Disabling of Auto Power Shut-off Mode

The auto power shut-off mode is used to turn off the power automatically once a programmed length of time has elapsed without any copier operation after the last copy of a run is made or power is turned on. This mode lowers the user’s electricity bill, reduces waste of natural resources, and cuts down on environmental pollution.

Depending on how the machine is to be used, you may wish for some reasons to disable this mode. This can be done using this program.

NOTE:

Since we would like you to fully understand the purpose of this mode, we suggest that you enable this mode and set the most appropriate time using program “AUTO POWER SHUT-OFF TIMER” (page 8-23).

To disable the auto power shut-off mode, press the check box of “DISABLING OF AUTO POWER SHUT-OFF MODE.” to display a check mark in the check box.

To restore the mode, press the check box of this program again to clear the check mark in the check box.

Disabling of Beep When Keys Touched

This program is used to enable or disable the beep function. If this function is enabled, a beep sound will be produced when you press a key on the operation panel including the touch panel.

To disable the beep function, press the check box of “DISABLING OF BEEP WHEN KEYS TOUCHED.” to display a check mark in the check box.

To enable the beep function, press the check box of this program again to clear the check mark in the check box.

KEY OPERATOR’S GUIDE

Key operator programs

CHAPTER8

8-29