Sharp AR-507 operation manual Adding Toner, Genuine Supplies, Open the front cover, toner hopper

ADDING TONER

The message “(TONER SUPPLY IS LOW. PRESS FOR GUIDANCE.)” will appear in the message display before the toner supply is completely empty. If copying is continued, copies will gradually become lighter until the copier stops and the message

display changes to “ADD TONER. PRESS FOR GUIDANCE.” indicating that the toner supply is empty. Toner can be added any time

after the message “(TONER SUPPLY IS LOW. PRESS FOR GUIDANCE.)” appears. To add toner, stop the copier and proceed as below. When either message appears, you can use the INFORMATION () key for detailed information as necessary.

During long copy runs of multiple originals containing many images and/or dark shades, “TONER REPLENISHMENT IN PROGRESS.” will appear and the copier will stop making copies even though toner is left. The copier will automatically cycle and replenish the toner to the normal level and then the START () key indicator will light up. Press the START () key to resume copying.

For best copying results, be sure to use only Sharp products. The package of Sharp toner has the Genuine Supplies label.

GENUINE SUPPLIES

1 Open the front cover.

CHAPTER4 SUPPLIES Adding toner

5X

20X

Pull down the toner hopper lock lever and pull the toner

2 hopper out slowly until it stops.

20X	Tap on the top of the toner cartridge 5 times. Hold the
	3 new toner cartridge vertically and vigorously shake it
	up and down about 20 times, then invert the cartridge
	and again shake it up and down about 20 times. This will
	loosen the toner and allow it to flow more easily into the
	toner hopper.

●When any caution label is attached to the new toner cartridge,read it carefully and remove it.

4-5