OK

DUAL PAGE

COPY

TRANSPARENCY

INSERTS

1 2 3 INTERRUPT

4 5 6

7 8 9 CLEAR

AUDIT CLEAR

PROGRAM

C

0 P

INTERRUPT

CLEAR ALL

CA

START

CLEAR

C

TANDEM COPY

5 Press the “OK” key.

Make all other desired copier settings and enter the

 

6 number of copies.

 

Thefunctionsselectedonthemaincopierwillbeusedbybothcopiers.

3CHAPTER

(1) The key operator programs of which settings at the main copier

 

are given priority (the settings at the sub copier are disregarded):

 

Exposure Adjustment, Toner Save Mode, Initial Margin Shift,

 

Erase Width Adjustment, Initial Status Setting, Staple Position

 

Setting, Date Format Setting, Date and Time Adjustment and

 

Disabling of Covers Mode.

 

SPECIAL

Disabling of Duplex Copying and Disabling of Stapler.

(2) The key operator programs for which the same settings

 

between the main and sub copiers are required:

FUNCTIONS

(3) The key operator program that can only be set at the main copier:

 

Disabling of Auto Paper Selection.

 

(4) In case of the other key operator programs than mentioned

 

above, different settings on the main and sub copiers

Tandem

respectively do not matter even when the tandem copying is

 

activated.

 

Ensure that paper of the same size selected in the main

copy

7 copier is installed in the sub copier.

Paper of the same size and same orientation must be installed in the two copiers. Even if the image of the original is rotated to match the copy paper in the main copier, the orientation of the copy paper in the sub copier must be the same as that in the master copier.

8

On the main copier, press the START ( ) key.

Images scanned by the main copier will be stored in both copiers.

Half the number of copies selected will be made simultaneously on both copiers. When the number of copies selected is odd, one more copy will be made on the main copier than the sub copier.

If the message “CHECK THE SUB MACHINE.” appears on the main machine, an error has occurred in the sub machine. Check the message on the sub machine and clear the error.

If the message “THE SYSTEM IS NOT CONFIGURED TO PERFORM TANDEM JOB. CODE: XX” appears on the main machine, refer to the tandem copy related descriptions in the TROUBLESHOOTING (see page 5-15).

To cancel a copy run after starting, press the CLEAR ALL ( CA ) key on the main copier.

To cancel the TANDEM copying, press the “TANDEM COPY” key again on the SPECIAL MODES screen of the main copier.

3-45

Page 79
Image 79
Sharp AR-507 operation manual Tandem Copy, Copier is installed in the sub copier, On the main copier, press the Start key