Sharp AR-507 operation manual KEY Operator Code Number, Registering the key operator code number

KEY OPERATOR CODE NUMBER

A key operator code number must be registered before a key operator program can be used. The key operator must remember this number. Only this registered number will allow access to the key operator programs.

6~200g/m2

CUSTOM SETTINGS	EXIT
DISPLAY	KEY OPERATOR
CONTRAST	PROGRAMS

		AUTO	AUTO A4				100%
		EXPOSURE	PAPER SELECT			COPY RATIO
		1	2			3	INTERRUPT
		4	5			6
		7	8			9	CLEAR
		AUDIT CLEAR			PROGRAM		C
			0			P
		KEY OPERATOR PROGRAMS					EXIT
		COPIER	COPIER			PDA/ZR
Key	KEY
operatorcode	OPERATOR’S	TOTAL COUNT.			PROGRAM LIST
					PRINTOUT.
number	GUIDE	KEY OPERATOR PROGRAMS
		COPIER MODE					OK
8CHAPTER		OTHER FUNCTION		TIMER SETTINGS
		SETTINGS
		ENABLE/DISABLE		ACCOUNT CONTROL
		SETTINGS

Registering the key operator code number

1 Press the CUSTOM SETTINGS ( ) key.

Press the “KEY OPERATOR PROGRAMS” key on the

2 touch panel.

●The following display will appear.

KEY OPERATOR PROGRAMS		EXIT
ENTER KEY OPERATOR CODE.
KEY OPERATOR CODE
- - - - -

Enter your key operator code number using the 10-key

3 pad.

●When registering the key operator code number for the first time, enter the number that was set at the factory. (See page 8-33.)

●As the code number is entered, the dashes in the display will change to asterisks.

4 Press the “COPIER” key on the touch panel.

5 Press the “OTHER FUNCTION SETTINGS” key.

8-2