Sharp AR-507 operation manual Finisher AR-FN3, Offset stack, Offset mode, NON-OFFSET mode

FINISHER (AR-FN3)

Offset stack

OUTPUT

TOP TRAY
OFFSET	SO
TRAY
OFFSET
AUTO	AUTO

In the initial setting, the offset tray will move from side to side so that each copy set is offset by approximately 30 mm (1.2 inch).

When the offset stack function is disabled, the offset tray will not move from side to side.

The offset stack function can be enabled or disabled by pressing the OUTPUT key and then the “OFFSET” check mark box on the touch panel.

When the STAPLE SORT mode is selected, the offset stack function will be disabled.

The top tray cannot be used to offset copies.

To select the top tray, press the “TOP TRAY” key on the touch panel. If the offset tray is selected, copies will be always delivered face down. If the top tray is selected, copies will be delivered face up or face down depending on copying settings.

NOTE:

When copying from the bypass tray onto special papers, be sure to select the top tray. If the offset tray is selected, a misfeed may occur.

OPTIONAL EQUIPMENT7

Finisher (AR-FN3) CHAPTER

3

2

1

3

2

1

OFFSET mode

1	1
			When copying in the SORT mode, each collated set of
			copies will be stacked offset approximately 30 mm (1.2
	1	2	inch) from the previous set. When copying in the GROUP

mode, copies will be offset stacked in groups of multiple copies from the same original.

NON-OFFSET mode 1

All copies will be aligned in one stack in the offset tray or

the top tray with no offset. 1

7-4