Sharp AR-507 Special Papers manual feed, Insert the copy paper all the way into the bypass tray

SPECIAL PAPERS (manual feed)

CHAPTER2 MAKING COPIES Special papers (manual

The bypass tray is used to copy onto transparency film, labels, tracing paper, and other special purpose papers. Up to 50 sheets of standard copy paper can be set in the bypass tray.

●Automatic duplex copying will not work when a non- standard sized paper is used. If a duplex copying mode is selected and a non-standard sized paper is used from the bypass tray, the corresponding one-

sided mode will be selected automatically when the START () key is pressed.

NOTE:

In this copier, copies are normally delivered face down. When copying onto special paper (including transparency film) placed in the bypass tray, however, copies will be delivered face up. When copying multi- page documents from the document glass onto special paper, copy from the last page to the first page. Also,

if an optional finisher (AR-FN3) is installed and the top tray output is selected, copy from the last page to the first page and then press the “READ-END” key on the touch panel. Copying will start after the “READ-END” key is pressed. In the default setting, paper placed in the bypass tray is always regarded as special paper and auto paper selection for the bypass tray is disabled.

★ KEY OPERATOR If the selection of paper type placed in the bypass tray is enabled, the type of copy paper can be specified on the touch panel after the “PAPER SELECT” key is pressed. Plain paper placed in the bypass tray can be regarded as plain paper and copies can be delivered face down. See page 8-22. And if auto paper selection from the bypass tray is enabled, paper placed in the bypass tray will be one of the alternatives of auto paper selection adding to other paper trays. See page 8-28. This function is available only when the selection of paper type placed in the bypass tray is enabled.

feed)

Place the original in the document feeder tray or on the

1 document glass.

2 Open the bypass tray.

Set the bypass tray guides to the width of the copy

3 paper.

●Be sure to extend the tray when feeding A4R, B4 or A3 (8-1/2"

x 11"R, 8-1/2" x 14" or 11" x 17") sized paper.

When feeding A3 (11" x 17") sized paper, pull out the metallic support.

Insert the copy paper all the way into the bypass tray.

4 ● Labels, tracing paper, and other special purpose papers other than SHARP recommended transparency film must be fed individually. Multiple sheets of SHARP recommended transparency film can be loaded in the bypass tray.

●Up to 50 sheets of standard copy paper measuring from A6 to A3 (5-1/2" x 8-1/2" to 11" x 17") can be loaded into the bypass tray.

●For automatic two-sided copying of A5 paper, position the side guides against the copy paper’s longest side.

●A6 size paper must be fed narrow side into the feed slot and must be fed individually.

●When adding paper, first remove remaining paper, combine it with the paper to be added and then reload as a single stack.

2-14