Sharp AR-507 operation manual KEY Operator Programs

KEY OPERATOR PROGRAMS

A complete list of all key operator programs is provided below. These programs can only be accessed by first entering the key operator code number.

The key operator programs are grouped into four categories: account control, other function settings, timer settings, and enable/disable settings.

KEY OPERATOR’S GUIDE8

Key operator programs CHAPTER

Category	Program Name	Function	Page No.
Account Control	Auditing Mode	Enables or disables the basic auditing mode, which	8-9
		controls access to copier.
	Number of Copies	Displays the total number of copies made against	8-9
	per Account	account numbers.
	Billing by Account	Displays the accumulated cost of copies against	8-10
		account numbers.
	Resetting Account	Resets all audit accounts or selectively resets	8-11
		individual accounts.
	Account Number	Registers accounts, deletes accounts, changes an	8-12
	Control	account number, or prints all registered account
		numbers.
	Price/Copy	Sets up to 3 levels of price per copy against account	8-13
	Setting	numbers.
	Account Limit	Sets the maximum number of copies which can be	8-14
	Setting	made against a registered account number.
	Account Number	Guards against trial and error entering of audit	8-15
	Security	account numbers.
Other Function	Key Operator Code	Changes the key operator code number.	8-16
Settings	Number Change
	Exposure	Lightens or darkens copies in the automatic	8-16
	Adjustment	exposure mode.
	Add or Change	Adds or changes reduction and enlargement preset	8-17
	Extra Preset Ratios	copy ratios.
	Setting a Maximum	Sets the maximum number of copies that can be	8-17
	Number of Copies	selected.
	Initial Margin Shift	Sets the initial margin shift values.	8-18
	Setting
	Erase Width	Sets the initial amount of the erase area.	8-18
	Adjustment
	Initial Status	Sets the copier’s initial settings in the ready	8-19
	Setting	condition.
	Stream Feeding	Enables the stream feeding mode for copying	8-19
	Mode	from the document feeder.
	Staple Position	Sets the initial stapling position setting for an optional	8-20
	Setting	finisher (AR-FN3).

8-4