Multifunctional settings
OPTION Menu
With the OPTION menu, the items shown in the table below can be performed.
Select an item using the cursor buttons ▲/▼ on the projector or remote control, and press the cursor button ► on the projector or remote control, or the ENTER button on the remote control to execute the item, except for the items LAMP TIME and FILTER TIME. Then perform it referring to the following table.
MENU [RGB] | :SELECT |
PICTURE | AUTO SEARCH TURN OFF |
IMAGE | AUTO OFF 0min |
INPUT | LAMP TIME 0h |
SETUP | FILTER TIME 0h |
SCREEN | SERVICE |
OPTION |
|
EASY MENU |
|
Item
Description
| Using the buttons ▲/▼ turns on/off the automatic signal search function. | |
| TURN ON TURN OFF | |
| This function works with INPUT, RGB, and VIDEO buttons. | |
| When the TURN ON is selected, detecting no signal automatically | |
| cycles through input ports in the following order. The search is | |
AUTO SEARCH | started from the current port. Then when an input is found, the | |
projector will stop searching and display the image. | ||
| ||
| RGB IN1 RGB IN2 COMPONENT VIDEO |
•When the RGB IN2/RGB OUT port functions as an RGB out port (the RGB IN OUT switch is pushed in), RGB IN2 cannot be selected. In that case “RGB2/RGB OUT RGB OUT” message will be displayed.
| Using the buttons ▲/▼ adjusts the time to count down to | ||
| automatically turn the projector off. |
| |
| Long (max. 99 minutes) Short (min. 0 minute = DISABLE) | ||
| AUTO OFF | AUTO OFF | |
AUTO OFF | ENABLE | DISABLE | |
1 | 0 | ||
| |||
| When the time is set to 0, the projector is not turned off automatically. | ||
| When the time is set to 1 to 99, and when the passed time with no- | ||
| signal or an unsuitable signal reaches at the set time, the projector | ||
| lamp will go off and the power indicator begins blinking. Please | ||
| refer to the section “Turning off the power”. | ||
| The lamp time is total lamp hours used after the last resetting of the | ||
| counter. It is shown in the OPTION menu as the usage time of the | ||
| lamp. |
| |
| Pressing the RESET button on the remote control or the button ► | ||
LAMP TIME | of the projector displays a dialog. To reset the lamp time, select the | ||
RESET using the button ▲. |
| ||
| RESET CANCEL |
| |
•Please reset the lamp time only when you have replaced the lamp, for a suitable indication about the lamp.
•For the lamp replacement, see the section "Lamp".
| The filter time is the time counted after the last resetting. It is shown | |
| in the OPTION menu as the usage time of the air filter. | |
| Pressing the RESET button on the remote control or the button ► of the projector | |
FILTER TIME | displays a dialog. To reset the filter time, select the RESET using the button ▲. | |
RESET CANCEL | ||
| ||
| • Please reset the filter time only when you have cleaned or replaced | |
| the air filter, for a suitable indication about the air filter. | |
| • For the air filter cleaning, see the section "Air filter". |
ViewSonic | PJ656 | 38 |
