ViewSonic VS11778 manual Programming Remote Control, Direct Device Code Setup, Aux

PROGRAMMING REMOTE CONTROL

Direct Device Code Setup

Although your Remote Control is set up to provide control of this LCD, you can specify other devices to be controlled, according to the following steps:

Each code in the following pages insists 5 digits from 0 to 9.

Mode → <<SET>> (2 blinks) → 5- digit device codes (2 blinks)

STEP 1 Locate the desired device in the Device code list.

STEP 2 Select the mode by pressing VCR, CBL, or AUX.

STEP 3 Depress and hold <<SET>> button for a minimum of 3 seconds until LED blinks twice.

STEP 4 Enter the 5-digit code for the desired device. The LED blinks located on the remote control once for every digit entered except for the last digit, where it shall blink twice to confirm that a valid code has been programmed.

	Mode	Device Assignment	Device
			Group no.
	TV	Locked to this LCD (Default)	-------
	VCR	Universal VCR, DVD, PVR	2
	CBL	Universal Cable, Satellite, Video Accessory	0
	AUX	Universal Tuner, Amplifier, CD, Mini Disc. And Misc. Audio,	3
		Home Automation
Example: [VCR]→<<SET>> (2blinks)→[2]→[0]→[0]→[3]→ [5] (2 blinks).

NOTE 1 : Each digit must be entered within 10 seconds, or the Remote Control shall exit the current programming state.

NOTE 2 : Two short LED blinks indicate valid code.

NOTE 3 : A long LED display indicates invalid code sequence. The code should be re-entered.

ENGLISH

ViewSonic CD4200 33