ViewSonic VS11959 warranty Message Status

Warning message

When the Lamp indicator lights up red or a message appears suggesting it is time to replace the lamp, please install a new lamp or consult your dealer. An old lamp may cause a malfunction in the projector and in some instances the lamp may explode.

The Lamp indicator light and Temperature warning light will light up if the lamp becomes too hot. Turn the power off and let the projector cool for 45 minutes. If the Lamp or Temp indicator still lights up after turning the power back on, please contact your dealer. See "Indicators" on page 42 for details.

The following Lamp warning displays will remind you to change the lamp.

Message	Status
Notice	The lamp has been in operation for 2000 hours.
	Install a new lamp for optimal performance. If
Order Replacement Lamp	the projector is normally run with "Economic
	Mode" selected (See "Lamp Mode (Normal)"
Lamp > 2000 Hours	on page 35), you may continue to operate the
	projector until the 2950 hour lamp warning
OK	appears.
Notice	The lamp has been in operation for 2950 hours.
	A new lamp should be fitted to avoid the
Replace Lamp Soon	inconvenience when the projector runs out of
	lamp time.
Lamp > 2950 Hours
OK
Notice	The lamp has been in operation for 3000 hours.
	It is strongly recommended that you replace the
Replace Lamp Now	lamp at this age. The lamp is a consumable
Lamp > 3000 Hours	item. The lamp brightness diminishes with use.
	This is normal lamp behavior. You can replace
Lamp usage time exceeded
	the lamp whenever you notice that the
OK	brightness level has significantly diminished. If
	the lamp is not replaced beforehand, it must be
	replaced after 3000 hours usage.
Notice	The lamp MUST be replaced before the
	projector will operate normally.
Out of Lamp-Usage Time
Replace lamp (refer to User manual)
Then reset lamp timer
OK

ViewSonic 39 PJ513D/PJ513DB