Viking D3 manual Preparation of the Oven, Ventilation System Preparing, Horizontal Exhaust Outside

7 Preparation of the Oven

Separate mounting plate from oven by removing two screws. See illustration below. Save these screws for use in section Mounting Oven to Wall, figure /.

4

figure	Mounting
	Plate

Back of Microwave

8 Ventilation System (Preparing

Oven for Installation)

This Built-in Microwave Hood is designed for adaptation to three types of hood ventilation systems. Select the type required for your installation.

Recirculating — non-vented, ductless.

Follow installation procedure (A). Recirculating requires the use of the Charcoal Filter, which has already been installed in the oven.

Horizontal Exhaust — outside ventilation. Follow installation procedure (B).

Vertical Exhaust — outside ventilation. Follow installation procedure (C).

(A)Recirculating: Non-Vented, Ductless Operation

•The unit is shipped assembled for recirculating.

•The Exhaust Damper Assembly 7 is not required

for recirculating operation.

(B) Horizontal Exhaust: Outside

Ventilation

5 figure

1)HORIZONTAL EXHAUST: Remove 2 screws from back edge and 3 screws from the top center of Fan Cover Bracket. Save 2 screws to be used later and discard remaining 3. Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow on the Fan Cover Bracket.

6	Hood Fan Unit
figure

2)HORIZONTAL EXHAUST: Lift Hood Fan Unit carefully and slip wires out of cavity.

•Caution: Do not pull or stretch hood fan wiring.

7	(A) Rotate 180˚
figure	(B)

3)HORIZONTAL EXHAUST: Rotate the Hood Fan Unit 180˚ so that the fan blade openings are facing the back of the oven. See Figure 7 (A). Replace Hood Fan Unit into the oven. Be careful not to pinch the wire and the Hood Fan

Unit. See Figure 7 (B).

E4