Electrical Requirements
General Information
Electrical Requirements
Check your national and local codes regarding this unit. This range requires
3 wire or 4 wire,
“Electrical Connection” section for grounding instructions. Must be fused
seperately from any other circuit.
WARNING
Electrical shock hazard. To avoid the risk of electrical shock, personal injury or death; verify electrical power is turned
off at the breaker box until the range is installed and ready to operate, installation by an authorized installer only.
READ AND FOLLOW ALL WARNING AND CAUTION INFORMATION WHEN INSTALLING THIS APPLIANCE.
•All openings in the wall behind the appliance and in the floor under the appliance must be sealed.
•DO NOT obstruct the flow of combustion and ventilation air.
Moving, Handling, and Unpacking
Remove and discard all packing materials, including cardboard and tape on the outside and inside of the range.
Range – Do not discard the
to “Anti-tip Device Installation” section.
Electric 30” Range
Electrical connection in this area
6”
(15.2 cm) 
(11.1 cm)
6”
(15.2 cm)
Some stainless steel parts may have a plastic protective wrap which must be peeled off. The interior should be washed thoroughly with hot, soapy water to remove film residues and any dust or debris before being used, then rinsed and wiped dry. Solutions stronger than soap and water are rarely needed.
8 | 9 |
