1716
1
Measurement (A)
Measurement (A)Measurement (A)
2
Measurement(A)
Measurement (A)
+1/2”
+1/2” (1.3 cm)
(1.3 cm)
Measurement(A)
+1/2” (1.3 cm)
3-5/8”
3-5/8”
(9.2cm)
(9.2 cm)
3-5/8”
(9.2cm)
Measure from floor to bottom
of the anit-tip opening located on the back of range.
This will be measurement (A).
Locateanti-tipbracketon rear wall withthe top left cornerat
measurement (A) plus1/2” (1.3 cm)from the floorand 3-5/8” (9.2cm)
fromwhere theright side ofrange (facingrange) is to belocated.
1

Note: Refer to electrical and gas

requirements section for proper

installation information.

3
Markand drill holes where bracket will belocated.
4
Attach bracket with
mounting hardware provided.
Connectgas and electrical.Before placing appliancein operation,
alwayscheck for gas leaks.This must be performed by your
dealer,a qualifiedlicensed plumber,or gas service company.
Leveling/Adjustments/Alignments (cont.)
Connecting Gas & Electric
WARNING

TIPPING HAZARD

Toreduce the risk of property
damage or personal injury;
install anti-tipping device
provided in accordance with
the installation instructions
in this document. Device
must be engaged properly to
prevent product from tipping
over.
7
Set the high cornerof range so that the top of sidetrim is
3/8” (0.95 cm) above countertop. Level range to high corner.
DANGER

GAS LEAK HAZARD

Toavoid risk of personal injury
or death; leak testing of the
appliance must be conducted
according to the manufacturer’s
instructions. Before placing appliance in
operation, always check for gas leaks
with soapy water solution.
• DO NOT USE AN OPEN FLAME TO
CHECK FOR GAS LEAKS.
Anti-tip Device Installation
Anti-tip Device Installation (cont.)